Logo

C3694 Engine Trouble Code

Meaning of C3694 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C3694 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C3694 code is occuring now you should check C3694 repair processes.
Now don't ask yourself; What should you do with C3694 code ?
The solution is here :

C3694 Possible Solution:

C3694 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

C3694 Code Meaning :

C 3 6 9 4
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Ignition System Or Misfire Fuel Temperature Sensor B Circuit Range/Performance Crankshaft Position Sensor A Circuit Malfunction Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C3694 OBD-II Diagnostic Chassis (C) Trouble Code Description

C3694 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For C3694 Code

The reason of C3694 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

C3694 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.